grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...
[Dan] salvaged some parts from an old printer a while back and finally found some time to play with them. One of the things he was most interested in is the geared stepper motor seen above. He was ...
Based on the Motorola (now Freescale) heavily used but obsolete SAA1042 stepper-motor-driver IC, this Design Idea describes a CPLD (complex-programmable-logic-device)-based implementation of a stepper ...
Seeing this Toshiba motor drive, my first thought was ‘what a neat chip for pairing with an Arduino’ as it combines operation across 1.8 to 7V with up to 4A drive – so that is Li-ion batteries, 5V USB ...
MIKROE has expanded its range of motor control boards with the launch of Stepper 28 Click, a compact add-on development board ...
For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...
Developers, makers and hobbyists that are looking for a way to control up to four motors using their Raspberry Pi mini PC. May be interested in a new control board that has been created by Justin ...
Oriental Motor is pleased to announce the arrival of the EtherNet/IP communication protocol to the αSTEP AZ Series AC Input stepper motor drivers. This new EtherNet ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results