There are a few options to do similar things with PCB layout, including tscircuit. There’s a walk-through for using it to create an LED matrix and you can even try it out online, if you like.

On a single-sided PCB design, the only option is to place the control IC on the top (component) side of the PCB close to the power devices. However, achieving short gate drive connections is often ...

Before the start of PCB layout, one good practice is to highlight the schematic traces for the high current traces, the noisy high dv/dt traces and the sensitive small signal traces with different ...

Designed for consumer and industrial power supplies, it delivers precise voltage regulation, overcurrent protection, and ...

Accidental Antennas Inverted F from TI’s Design Note 007 A trace antenna is an antenna made out of a small strip of copper wire on the PCB which just happens to resonate at certain frequencies.

Eventually, almost every EE must design a PCB, which isn’t something that’s taught in school. Yet engineers, technicians, and even novice PCB designers can create high-quality ...

Adaptive optimization algorithms promise better results and deeper insight into why certain designs perform better than ...

The PCB layout supports multi-layer boards (up to 30 layers), as well as DRC. There is not yet an autoplacer, but this is high priority on the company’s roadmap, as is an autorouter.

Tools that support collaborative design, such as cloud-based PCB design software, further enhance this streamlined workflow by allowing real-time collaboration and updates. Enhanced Knowledge Sharing ...

Any electronic device where reliability, safety or harsh environmental exposure is a concern can benefit from HALT and HASS ...